PRE UNIT CLUTCH PRESSURE PLATE 48-62-TRIUMPH

PRE UNIT PRESSURE PLATE FOR A TRIUMPH 500 AND 650. THIS IS A 4 HOLE PRESSURE PLATE MADE IN ENGLAND BY MCA. IF YOUR CHAIN WHEEL AND REBOUND UNIT IS ALL NOTCHED FROM THE TANGS ON THE PLATES IT CAN CAUSE YOUR CLUTCH TO DRAG. IF YOUR REBOUND UNIT ID OVER WORN IT CAN CAUSE HARD SHIFTS PUTTING UNDUE WEAR ON YOUR TRANSMISSION. THERE IS AT POINT WHERE REPLACING THE RUBBERS INSIDE ISN'T ENOUGH. THE SPIDER GEARS AND PLATES ALSO WEAR TO THE POINT WHERE THEY NEED TO BE REPLACED. WHEN REPLACING THE CHAIN WHEEL YOU SHOULD REPLACE THE BONDED PLATES AS WELL. WE DO RECOMMEND WHEN REPLACING CLUTCH PLATES TO ALSO REPLACE YOUR SPRINGS. THIS WILL ELIMINATE CLUTCH SLIPPAGE. AS LONG AS YOUR CLUTCH ROD AND CABLE ARE ADJUSTED PROPERLY AFTER YOU REBUILD YOUR CLUTCH. ALSO DON'T FORGET YOUR PRIMART GASKET AND PLEASE INSPECT YOUR OTHER PRIMAR PARTS WHILE YOU HAVE IT ALL OPENED UP. WE WILL BE HAPPY TO HELP YOU WITH WHAT TO LOOK FOR WHEN CHECKING. JUST CALL.